| Subject: | Sync Palm with Virtual PC for the Mac | |
| Date: | 2003-10-08 17:42:18 | |
| From: | anonymous2 | |
|
Response to: Sync Palm with Virtual PC for the Mac
|
||
|
hi there, I have the same problems, that I can not sync my clié NZ 90 with virtual pc 5.0 (Windows 98 / Outlook 2000). Even when I disable the hotsync manager on my Mac (OS 10.2.6) the sync doesn't work. I can see the Sony handheld in both the system settings / devices and the virtual pc usb settings. But it doesn't work. What do you mean saying "set up the sync process as you normally would on the PC"? Shall I use USB- or Com-Ports and if Com-Ports, which baud-ratings and other settings do I need. So please help a little German idiot. I was trying every setting you could imagine, I think.
|
||
Showing messages 1 through 2 of 2.
-
Sync Palm with Virtual PC for the Mac
2004-02-10 00:21:08 stevendn [Reply | View]
-
Sync Palm with Virtual PC for the Mac
2007-05-18 07:06:17 DaTinman [Reply | View]
I had exactly the sam eproblems as all of you guys. I disabled the hotsync manager in the mac then tried to sync and it wasnt haveing any of it. But then I played around with it for a bit and got it to work. Basically I disabled the hotsync manager for the mac launched VPC then launched palm desktop in windows. Next i went to the tab that said hotsync clicked it and went to setup (sometimes its greyed out because the hotsync manager for windows hasnt started up yet. if that happens relaunch palm desktop and hopefully the hotsync icon will appear inn the bottom left hand corner) then switch in setup to com port 2 on all the windows and in the last one that say TCP IP setings or whatever check the book that has your user name then click the bottom that brings up a dialouge with an ip number like 192.63.56 etcthen click ok. Then click hotsync on the cradle. You may have to go into the USB sttings window for VPC as soon as youve done it and check to see if the cradle is checked even if it is it sometimes helps to uncheck it then check it again. Even though this works now it dosent always launch (tempremental) and dosent always finish the sync but at least it starts and it dose appear to work although i think the problem is that the VPC is ultra slow in OS X. Hope that helps people
Finally with Virtual PC running and the PC Palm desktop open, I pushed the hotync button on the cradle and then checked the USB Settings (commnd-T and then USB settings) under the enable USB Checkbox, Palm handheld will appear. You can then enable this.
Hope this helps