Article:		WAP11 to WET11: Easy, Cheap Wireless Bridging
Subject:		wet11/philips i200
Date:		2003-02-22 15:07:00
From:		eggboard
Response to: wet11/philips i200
Set up the Philips on the Ethernet network first. Then set up the WET11 to connect to your WLAN and confirm that it is through its status page. Then disconnect the Philips from the wired LAN and plug it into the WET11. To the Philips radio, the WET11 is invisible. The WET11 proxies its MAC address to the Ethernet network and brings Ethernet traffic back to the Philips. Have you tried this and it failed, or have you wondered how to do it before trying it?

Showing messages 1 through 1 of 1.

• wet11/philips i200
  2003-02-22 15:20:18  anonymous2 [Reply | View]
  
  
  I went the other way around, configuring the WET11 and then plugging in the i200 - which could not ever connect. I will try it in your order since I could not tell, the way I did it if the problem was the WET11 configuration or the i200 configuration.
  Thanks